Dip Switch - Belkin OmniView PRO Guide De L'utilisateur

P73055/F1D108-OSD/EU/man.qxd
PLEASE FOLLOW THIS INSTALLATION PROCEDURE EXACTLY. NOT DOING SO MAY RESULT
IN KEYBOARD AND/OR MOUSE ERRORS, OR FAULTY OPERATION.
WARNING: Before attempting to connect anything to the OmniView
the computers, make sure everything is powered off. Plugging and unplugging
cables may cause irreversible damage to your computers and the OmniView
PRO. Belkin Components will not be held responsible for damage caused.
1.
Set the DIP switches. If you have only one OmniView
If the OmniView
slave setting. Please refer to the previous section for more information.
2.
Find a convenient place to put your OmniView
for 48.3cm racks. When mounting to a rack, attach the included brackets to the sides of
the OmniView
OmniView ™
4/21/00 2:25 PM
Hardware Installation
PRO you are using will be daisy-chained off another unit, use a unique
™

DIP SWITCH #

4 5
3
ON ON ON
OFF ON ON
ON OFF ON
OFF OFF ON
ON ON OFF
OFF ON OFF
ON OFF OFF
OFF OFF OFF
ON ON ON
OFF ON ON
ON OFF ON
OFF OFF
ON
ON ON OFF
OFF ON OFF
ON OFF OFF
OFF OFF OFF
NOTE: "ON" is down
™ PRO. Take note of the length of your cables so that your computers,
PRO, keyboard, mouse, and monitor are distanced properly.
Page 6
(continued)
PRO, use the MASTER bank setting.
™
BANK ADDRESS
6
BANK 0 MASTER
ON
BANK 1 slave
ON
BANK 2 slave
ON
ON BANK 3 slave
ON BANK 4 slave
ON BANK 5 slave
ON BANK 6 slave
ON BANK 7 slave
OFF BANK 8 slave
OFF BANK 9 slave
OFF BANK A slave
OFF BANK B slave
BANK C slave
OFF
BANK D slave
OFF
OFF BANK E slave
BANK F slave
OFF
™ PRO. Its 48.3cm form factor makes it ideal
6
™ PRO or
™