Technical Characteristics; Necessary Connections; Installation And Basic Adjustments; Usage Location - Fiamma PRESTIGE ECC Manuel D'instructions

SEMI-AUTOMATIC MACHINES
The semi-automatic models feature a switch button above each
3.2.

Technical characteristics

 The main technical characteristics are fixed on the type plate on the machine.
3.3.

Necessary connections

1 Water tap with a G3/8 nut (for the water supply tube)
1 drain pipe with drain hose with minimum 16/17 mm diameter
1 earthed electric mains supply with a 30mA protection and a 20 A circuit breaker (machine with 2
groups) or 25 A (machine with 3 groups)

4. Installation and basic adjustments

4.1.

Usage location

Choose a dry location for the coffee machine where it cannot come in direct contact with water.
Do not direct water jets onto the equipment!
Choose a stable and leveled surface to place the machine on.
Install the machine at a safe distance from inflammable or heat-sensitive materials. If this is not
possible, isolate the space surrounding the machine with a non-inflammable, heat resistant
isolation material.
In places where the temperature can drop below freezing point, leave the machine switched on in
order to avoid that frozen water damages groups and pipes.
Install the machine with a water filter system.
 Leave enough space next to the machine for the water purifier and a grinder
 The ideal ambient temperature is at least 15ºC and maximum 25ºC.
4.2.

Unpacking

Before using the machine for the first time, remove all plastic protections. Make sure the machine is
complete. Dispose safely of the plastic wrapping as they are potentially dangerous. Clean the exterior of
the machine with a soft humid cloth.
4.3.

Installation to water

In case the machine is not connected to the water net with a pressure above 1 bar, we strongly
recommend to use a anti-reflux valve in the water supply hose.
1. Place the machine in an even and leveled position on the counter, ideally in its final working
position.
2. Place the water filter system and install it to the water supply and the machine following the
manufacturer's instructions, using the water supply tube that is already connected to the machine.
3. Connect the water drain hose to the drain pipe.
4. Loosen the electric feeding cable and proceed to the electrical installation.
4.4.

Electrical installation

To avoid the risk of damage to the machine, make sure that the rating on the data plate
corresponds to the voltage and frequency of the power supply.
Only connect the machine to an earthed mains supply!
Prestige ECC Espresso Coffee Machines by fiamma - Operating Manual - 30/09/2015
ENGLISH
group.
19