Physical And Operational Specifications; Dimensions; Replacement Motor Guide - Zodiac Jandy Pro Serie VS FloPro Manuel D'installation Et De Fonctionnement

Page 26
English
7.4

Physical and Operational Specifications

7.4.1 Specifications
Model no.
VS-FHP 2.0
7.4.2

dimensions

Table 4 shows the height of the FHP pump in the three (3) mounting configurations listed below. Figures 3, 4, and 7,
on page 10, shown drawings of these three (3) configurations.
1. Without the FHP base
2. With the FHP base
3. With the FHP base and spacers
The width of the FHP base (with or without spacers) is 8⅞".
Table 4. Fhp dimensions
Base Configuration
Pump without Base
Pump with Base
Pump with Base and
Spacers
The figure below shows the dimensions (height, width, and length) of the FHP pump without the FHP base and spacers.
25.5 cm
10"
16.5 cm
6 1/2"
Bolt Holes,
Center to Center
noTE
When installing a pump, leave a minimum of two (2) feet (30 cm) of clearance above the pump for removal of the strainer basket.
7.5

replacement Motor guide

Pump Model
VS-FHP 2.0
Jandy Pro Series VS FloPro
®
hp Voltage
2.0 230 VAC 2,400 W
suction
pump
side
height
height
7 ¾" 12¾"
8⅞" 13⅞"
9⅛" 14⅛"
32.3 cm
12 3/4"
19.7 cm
7 3/4"
Jandy
R0562200
Variable-Speed Pump
™
Watts pipe size
2½ - 3"
69 cm
27 3/16"
A
28.2 cm
11 1/8"
27.5 cm
10 7/8"
Front Edge of Union
to Center of Bolt Holes
|
Installation & Operation Manual
Carton Weight overall length 'a'
56 lbs. 69 cm (27 3/16")