Spraying Technique; Breaks In Work; Transportation; Taking Out Of Operation And Cleaning - Titan Tool Focus 500 Mode D'emploi

Focus 500
9

SPRAYING TECHNIQUE

The Focus 500 has a trigger with 2 pressure points.
The turbine is started via the first pressure point. If
the trigger is pressed further, the material is trans-
ported.
Operate trigger on the spray gun.
Test spray a piece of cardboard to ensure correct setting of the
spray pattern, spray jet width, material and air volume.
Hold the paint spray gun upright and maintain a constant
distance of about 3 - 20 cm to the object being sprayed. (Fig.
10)
Move the paint spray gun evenly either from side to side or up
and down. If the gun is moved evenly, it will produce an even
surface finish.
Always start spraying away from the object and avoid stopping
spraying whilst still on the object.
In case of excessive paint mist formation, adjust the air and
material flow respectively and alter the distance from the
object.
10

BREAKS IN WORK

1. Unplug the power plug.
2. During longer breaks, vent the container by briefly opening
and then closing it again.
3. Clean nozzle openings after an interruption in operation.
In using quick-drying or two-component coating
materials, do not fail to rinse unit through with
a suitable cleaning agent during the processing
period.
11

TRANSPORTATION

ATTENTION! Full containers have to be
closed tightly when transported in the
case. Do not lie the case on its side if it
contains full containers of paint.
1. Detach the carrying strap from the device and secure it to
the case (fig. 24).
2. Put the Focus 500 and accessories inside the case as shown
in fig. 25 and secure with elastic straps.
SPRAYING TECHNIQUE / BREAKS IN WORK / TRANSPORTATION/

TAKING OUT OF OPERATION AND CLEANING

Press the right and left inside of the case lid out-
wards in order to open up the transport case com-
pletely.
12
TAKING OUT OF OPERATION AND
CLEANING
In order to ensure smooth operations, the Focus
500 has to be cleaned thoroughly every day.
1. Divide the spray gun. Press catch (Fig. 2, A) down slightly.
Twist the spray attachment and turbine in a counter
movement to disconnect them from each other.
ATTENTION! Never hold the spray gun
rear part under water or immerse it into
liquids. Clean the housing only with a
moistened cloth.
2. Unscrew the container.
Empty the remaining coating material into the original
container.
3. Pre-clean the container and feed tube using a
brush and suitable cleaning agent.
Clean the ventilating bore. (Fig. 9, 2)
4. Fill the container with a non-flammable solvent or
water. Screw the container back on.
Do not spray flammable materials for cleaning purposes.
When cleaning devices with flammable
solvents, disconnect the device from the
mains and clean thoroughly with a brush
and cloth. Before starting the device up
again, ensure that all traces of solvents
are removed thoroughly. Allow the clea-
ned parts to dry completely.
5. Connect spray attachment and gun handle. (Fig. 2)
6. Pull the trigger to rinse the spray attachment.
Repeat the above procedure until the solvent or water
emerging from the nozzle is clear.
7. Turn off the machine and divide the spray gun.
8. Screw off the container and empty it.
Unscrew feed tube with container seal. (Fig. 11)
9. Clean feed tube and suction nozzle in spray attachment
GB
19