Setting The Temperature - Philips EasyCare GC8351 Mode D'emploi

EnGlish
8
1 Remove the detachable water tank from the steam generator (Fig. 3).
2 Fill the water tank with tap water up to the MAX indication.
Note: If the tap water in your area is very hard, we advise you to mix it with an equal amount
of distilled water.
3 Slide the water tank firmly back into the steam generator ('click').
Note: If the water tank is not properly placed, the iron does not produce any steam.
Water tank refill light
When the water tank is empty, the water tank refill light starts flashing and steam ironing is no
longer possible.
1 Remove the water tank and fill it.
2 Put the water tank back into the steam generator.
The iron is ready for steam ironing again.
,

setting the temperature

1 Check the laundry care label of the article to be ironed to determine the required ironing
temperature.
- 1 for synthetic fabrics ( e.g. acrylic, viscose, polyamide) and silk
- 2 for wool
- 3 for cotton
- MAX for linen
2 To set the required ironing temperature, turn the temperature dial to the appropriate
position (Fig. 4).
3 Put the mains plug in an earthed wall socket.
4 Switch on the appliance.
- Press the on/off button once (Fig. 5).
The power-on light of the on/off button goes on.
,
The temperature light on the iron goes on. When the iron has reached the set temperature,
,
the temperature light goes out.
Note: During ironing, the temperature light goes on from time to time. This indicates that the iron is
heating up to the set temperature.
The steam light starts flashing. After approx. 2 minutes, the steam light stays on continuously
,
to indicate that the steam generator is ready for steam ironing.
tips
- If you do not know what kind or kinds of fabric an article is made of, determine the right ironing
temperature by ironing a part that is not visible when you wear or use the article.
- If the fabric consists of various kinds of fibres, always select the temperature required by the most
delicate fibre, i.e. the lowest temperature. For example: if a fabric consists of 60% polyester and
40% cotton, it must be ironed at the temperature indicated for polyester ( 1) and without steam.
- Start ironing the articles that require the lowest ironing temperature, i.e. those made of
synthetic materials.
- If you set a lower temperature during ironing, wait until the iron has cooled down to the set
temperature before you continue ironing. To make the iron cool down faster, simply press the
steam trigger or iron a piece of cloth.