emerio FN-121056 Mode D'emploi page 6

2. The whole assembly
Loosen the fastening screw on the standing shaft. Insert the upper column into the standing shaft. Tighten

back the fastening screw.
Loosen the fastening screw on the upper column. Insert the motor unit into the upper column. Tighten back

the fastening screw.
3. Rear grille assembly
Loosen the blade fastening screw and remove the motor shaft sleeve (A) from the motor shaft.

Remove the black blade fixed buckle (B) from the rear guard. Separate the rear guard and the fan blade.

Align the chute in the center of the rear guard with the sliding slot in the center of the motor unit. Attach

a d the lift the ea gua d up a ds u til a li k sou d is hea d. To remove the rear guard, push the clip (C)
upwards and meanwhile press down the whole rear guard.
Align the chute
A
- 5 -
B
C
Lift