Control Panel Operation & Tapping Function - 39-D 251 - Walter ICECUT 250 Manuel D'instructions

Icecut 250 & Icecut 250P
8) CONTROL PANEL OPERATION & TAPPING FUNCTION
When tapping, always use the lowest gear with the lowest speed. Never tap without
applying tapping or cutting fluid, ensuring a smooth cut and prolonged tool life.
Drill the hole to the recommended tapping size for the thread to be cut. Information can
be found on the Walter website (www.walter.com).
Once cutting, the tap will start to feed itself through the hole. When using the reverse
speed, only gentle pressure on the feed handles should be necessary, and the tap will
push itself out of the hole.
Original Instructions
12
ICECUT 250P (39-D 251)
12-2018