Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
14.
Slide a rear hopper tube (11) onto the two upper
hopper tubes (6). See figure 10.
15.
Secure the upper hopper tubes (6) to the rear hopper
tube (11) using two 1/4" x 1" curved head bolts (26)
and 1/4" nylock nuts (24). See figure 10.
noTe: Hopper bag (3) not shown for clarity.
26
6
16.
Slide the bag frame tube (1) through the front flap of
the bag. See figure 11.
17.
Secure the bag frame tube to the bottom hopper
tubes using two 1/4" x 1.11" clevis pins (28) and 3/32"
cotter pins (19). See figure 11.
18.
Secure the top and bottom hopper tubes together
using two 5/16" x 3/4" hex bolts (17) and 5/16" nylock
nuts (21). See figure 11.
21
17
19
28
1
11
24
26
6
FIGure 10
17
21
19
28
FIGure 11
19.
Using a hammer, tap a palnut (23) onto one end of
the pivot rod (2). See figure 12.
20.
Slide the end of the pivot rod that doesn't have a
palnut on it through the holes in the side of the upper
hopper tubes and through the middle flap of the bag.
See figure 12.
21.
Using a hammer, tap a palnut (23) onto the other end
of the pivot rod (2). See figure 12.
24
2
22.
Insert the hopper support rods (7) into the holes in
the upper hopper tubes and then into the rear bottom
hopper tubes as shown in figure 13.
noTe: The hopper support rods will bend about as much
as shown in figure 13 when they are assembled.
7
6
2
23
FIGure 12
7
FIGure 13
Publicité
Table des Matières
