To Attach Stand Mixer Attachment; Before Attaching Stand Mixer Attachment; Food Grinder Attachment; To Assemble Food Grinder Attachment - KitchenAid FGA Instructions

To Attach Stand Mixer Attachment

Before Attaching Stand Mixer
Attachment
1. Turn Stand Mixer speed control to OFF.
2. Unplug mixer.
3. Loosen the attachment knob (A) by
turning it counterclockwise.
4. Remove the attachment hub cover or
flip up hub cover.
5. Insert the attachment shaft housing (B)
into the attachment hub (C) making
certain that attachment power shaft
fits into square hub socket.
6. It may be necessary to rotate the
attachment back and forth. When the
attachment is in proper position, the
pin on the attachment housing will fit
into the notch on the hub rim.

Food Grinder Attachment

B

To Assemble Food Grinder Attachment

1. Insert the grind worm (A) into the grinder body (B).
2. Place the knife (C) over the square shank at the exposed end of the grind worm.
3. Place grinding plate (D) over the knife, matching the tabs of the plate with the
notches of the grinder body.
4. Place ring (E) on grinder body, turning by hand until secured but not tightened.
NOTE: The combination food pusher/wrench (F) is used for removal of ring (E) only.
Do not use it to tighten ring (E).
NOTE: Fruit/Vegetable Strainer (Model FVSP) is available to convert Food Grinder to a
Fruit/Vegetable Strainer.
Sausage Stuffer (SSA) is available to convert Food Grinder to Sausage Stuffer.
7. Tighten the attachment knob by turning
C
Fine
A
4
it clockwise until the attachment is
completely secured to mixer.
B
D
Coarse
E
C
A
F