Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Hold the tool firmly with one hand on the left side handle
and the other hand on the right side handle
right hand apply weight to the on/off switch
Apply only enough pressure to the work area to engage the
active vibration control. Applying too much pressure will
not make the pavement breaker chisel faster and the active
vibration control will not engage.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. C)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on each side
handle.
Fig. C
Bits (Fig. D, E)
WARNING: To reduce the risk of injury, turn unit
off and disconnect it from power source before
installing and removing accessories, before
adjusting or when making repairs. An accidental
start-up can cause injury.
WARNING: ALWAYS wear gloves when you change
bits. Accessible metal parts on the tool and bits may
get extremely hot during operation.
WARNING: To reduce the risk of injury, only D
recommended accessories should be used with this
product. A variety of bits are available from your
local retailer.
nOTE: Insert bits with the front of tool
To insert air steel bits (ring-only bit)
1. Pull bit retainer
open as shown in Figure D.
4
3
2. Insert bit into bit holder
2
. Using the
Fig. D
1
to turn on.
To insert tool steel bits (notch-only bit)
1. Pull bit retainer
2. Insert bit with notch
3. Pull bit retainer up to lock into position as shown in
Fig. E
Use either of the above methods to insert combination steel
(notch and ring bit)
To Operate
nOTE: Use sharp bits only.
1. Insert bit as described in Bits.
2. Standing behind the tool with both hands on the
3. Remove hand to relieve pressure from the on/off switch
MAINTENANCE
WALT
e
6
facing up.
5
and close bit retainer onto
bit as shown in Figure D.
5
4
4
4
open as shown in Figure E.
8
facing up into bit holder
Figure E.
4
5
8
handles, depress the on/off switch
Hold handles firmly to control tool.
to turn the tool off.
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
English
5
.
4
1
to start the tool.
5
Publicité
Table des Matières
