Charging The Rechargeable Battery - Einhell Royal AHS 24 Instructions De Service

Anleitung AHS 24 SPK1 01.12.2004
1.26 Vibrations on the handle were measured in
accordance with EN 786 Anhang D: 1996 + A1:
2001.
Explanation of rating plate (see Figure 7)
1. Warning
2. Keep away from the rain and damp conditions.
3. Read the operating instructions before you use
the hedge trimmer.
4. Wear goggles and ear-muffs or similar protection.

3. Charging the rechargeable battery

1. To remove the rechargeable battery, press the
two locking clips (A) firmly and at the same pull
the battery backwards and out, as shown in Figs.
2 + 3.
2. Check that the mains voltage is the same as that
marked on the rating plate of the battery charger.
Connect the power supply unit to the recharge-
able battery. Plug the power supply unit in the
plug socket. The green and the red LEDs on the
rechargeable battery will illuminate (Fig. 6).
3. An empty battery requires approx. 7 hours to re-
charge. The recharging time is correspondingly
shorter if the battery has any residual capacity.
The temperature of the battery may rise slightly
during the charging operation. This is normal.
If the battery pack fails to charge, please check
whether there is voltage at the socket-outlet
whether there is good contact at the charging
contacts
If the battery pack still fails to charge, we request that
you send
the battery charger
and the rechargeable battery pack
to our customer services department.
To ensure that the NC battery pack provides long
service, you should take care to recharge it promptly.
You must recharge the battery pack when you notice
that the power of the hammer screwdriver drops.
Never allow the battery pack to become fully dis-
charged. This will cause it to develop a defect.
To install the rechargeable battery, insert it in the
battery compartment on the trimmer as shown in
Fig. 2. Make sure that the battery interlocks with
the battery guide in the trimmer housing. Then
slide the battery into the battery compartment as
far as the stop. The two locking clips (Fig. 3/A)
10:56 Uhr Seite 11
will lock into the trimmer housing in the process.
As an alternative you can charge the rechargeable
battery directly on the device.
Never switch on the device during recharging.
4. Using for the first time and
mode of operation
1 Blade
34.105.70.01.001
2 Hand guard
34.105.70.01.002
3 Guide handle with button switch
34.105.70.01.003
4 Handle with switch
34.105.70.01.004
5 Battery pack
34.105.70.01.005
6 Charge socket
Caution! This hedge trimmer is designed to cut hed-
ges, bushes and shrubs. Any other use which is not
expressly permitted in these instructions may cause
damage to the hedge trimmer and place the user at
serious risk. Your hedge trimmer is equipped with a
two-hand safety circuit. This means that it works only
when the switch button on the guide handle (Figure 1
/ Item 3) is pressed with the one hand while the
switch on the handle (Figure 1 / Item 4) is being pres-
sed with the other hand. If you let go of either swit-
ching element, the blades will stop moving.
The blades take time to slow down to a standstill.
Please make allowance.
- Check that the blades are working properly. High
cutting performance and smooth operation are
guaranteed by the counter-rotating, dual-edge
blades.
5. Practical tips (Fig. 4+5)
b The hedge trimmer can be used to cut shrubs
and bushes as well as hedges.
For the best performance, hold the hedge trim-
b
mer with its teeth at an angle of approx. 15° to
the hedge.
b Cutting in both directions is possible with the
counter-rotating dual-edge blades.
b To trim your hedge to a uniform height, run a
length of string along the hedge for guidance and
cut off the projecting branches.
b Cut the sides of the hedge with sweeping move-
ments from the bottom up.
GB
11