To Remove A Shelf; Electrical Connection - CASO DESIGN WineSafe 18 EB Mode D'emploi

may cause injury or material damage.
12.5.7

To remove a shelf

Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out.
► Ensure that the tabs are firmly engaged in place before storing any bottles.
► Any of the wine shelves can be removed to accommodate larger bottles.
► Spread your bottles out as evenly as possible over the shelves, so weight is not
concentrated in one point; and make sure your bottles will not touch the back of the
cabinet.

12.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
Please note
Warning
► Do not store bottles crosswaves on the
interior floor! Otherwise, bottles may fall out
when the appliance door is opened and this
37