Samsung HW-F850 Mode D'emploi page 22

functions
TV
SMART VOL
AUDIO SYNC AUDIO SYNC SMART VOL SPEAKER SMART VOL SPEAKER
MUTE MUTE
S/W LEVEL S/W LEVEL S/W LEVEL VOL VOL
TONE TONE
TV CH TV CH
TV CH TV CH
AUTO POWER AUTO POWER AUTO POWER
DRC DRC REPEAT REPEAT
AUDIO SYNC AUDIO SYNC SMART VOL SPEAKER SMART VOL SPEAKER
TV CH TV CH
AUTO POWER AUTO POWER
DRC DRC REPEAT REPEAT
AUDIO SYNC AUDIO SYNC AUDIO SYNC SMART VOL SPEAKER SMART VOL SPEAKER
TV CH TV CH
AUTO POWER AUTO POWER
DRC REPEAT REPEAT
AUDIO SYNC AUDIO SYNC SMART VOL SPEAKER SMART VOL SPEAKER
22
Using the SMART VOL function
This will regulate and stabilize the volume level against a drastic volume
change caused by a channel change or scene transition.
Press SMART VOL on the remote control.
• Each time the button is pressed, the selection changes as follows :
SMART VOLUME ON ➡ SMART VOLUME OFF
Using the S/W LEVEL function
You can control the base volume with the S/W LEVEL button on the remote
control.
1. Press an S/W LEVEL button on the Remote control.
2. "SW 0" appears on the display.
3. Press or button on the LEVEL key if you want to increase or
decrease the subwoofer volume. You can set it from SW -6 to SW +6.
Using the AUTO POWER LINK function
The Crystal Surround Air Track is automatically turned on when you turn on
the TV or any device connected to the Air Track with the optical cable.
Press AUTO POWER on the remote control of this unit.
• The Auto power link function turns on and off each time you press AUTO
POWER.
AUTO POWER LINK
ON
OFF

If a TV or any device connected to Air Track with the optical cable is
off and there is no digital input, the Air Track is turned off after 20
minutes.

These functions are available only when the Anynet+ (HDMI-CEC) is
turned off.
Using the AUDIO SYNC function
Video may appear out of synch with the audio if the Air Track is connected to
a digital TV. If this occurs, adjust the audio delay time to match the video.
Press AUDIO SYNC
• You can use the ,
and 300 ms.

In USB mode, TV mode or BT mode, the Audio Sync function may
not work.
Using the DRC function
This feature balances the range between the loudest and quietest sounds.
You can use this function to enjoy Dolby Digital sound when watching movies
at low volume at night.
Press DRC on the remote control of this unit.
• Each time the button is pressed, the selection changes as follows :
DRC STANDARD ➡ DRCMAX ➡ DRCMIN
POWER LINK ON
POWER LINK OFF
/ on the remote control of this unit.
buttons to set the audio delay time between 0 ms
Display