Tools Needed For Assembly; Electrical Requirements - Luminance Brands Kathy Ireland Home SUMMER NIGHT CF652BQ01 Manuel Du Propriétaire

1. Unpacking Instructions
THESE FAN MODELS ARE SUITABLE FOR DAMP LOCATIONS SUCH
AS COVERED PORCHES, COVERED PATIOS, AND COVERED DECKS...
This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips Head Screwdriver
One Standard Screwdriver
Materials
Wiring outlet box and box connectors must be of type required
by the local code. The minimum wire would be a 3-conductor
(2-wire with ground) of following size:
Installed Wire Length
Up to 50 ft.
50-100 ft.
Your new Ceiling Fan will require a Grounded Electrical Supply
Line of 120 Volts AC, 60 Hz, 15 Amp Circuit.
The Outlet Box must be securely anchored and capable of
withstanding a load of at least 50 Pounds.
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable
for Fan Support of 22.7 kg. (50 lbs.) or less", and
use screws supplied with outlet box. Most outlet
boxes commonly used for support of light fixtures
are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
If your Fan is to replace an Existing Ceiling Light Fixture,
turn Electricity OFF at the Main Fuse Box or Circuit Breaker
Panel at this time and remove the Existing Light Fixture.
ANYWHERE THERE IS A ROOF OVERHEAD.
One Stepladder
One Wire Stripper
Wire Size A.W.G.
14
12

2. Electrical Requirements

(Continued)
!
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 13).
If you feel you do not have enough wiring knowledge
or experience, have your fan installed by a licensed
electrician.
Controls
SW46 Wall Control (sold separately) may be used with this
52" SUMMER NIGHT Ceiling Fan.
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box or circuit breaker panel before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
!
To avoid fire or shock, follow all wiring instructions
carefully.
A n y e l e c t r i c a l w o r k n o t d e s c r i b e d i n t h e s e
instructions should be done or approved by a licensed
electrician.
Please call Customer Service at 1-800-777-4440
if you have any questions about installation and operation of
this Ceiling Fan.
4
WARNING
(Sold Separately)
WARNING
WARNING
U.L. Model No.: CF652