Protect The Environment - Remington Volumiser CB65 Mode D'emploi

ENGLISH
Special tools are required for any examination, adjustment or repair. Unqualified repair
work could lead to hazardous conditions for the user.
We do not accept responsibility for damage to the product, persons or other item(s),
caused by misuse, abuse or non-compliance with these instructions
This product is fitted with a BS1363 plug fused at 13A. If the plug is unsuitable, it should be
disconnected and an appropriate plug fitted as detailed below. If it is necessary to replace
the plug fuse, use only fuses that are approved to BS1362, rated at
qualified electrician.
The wires in the mains lead are coloured in accordance with following code:
BLUE – NEUTRAL
BROWN – LIVE
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:-
The wire which is coloured BLUE must be connected to the terminal which is marked
'N' or coloured BLACK. The wire which is coloured BROWN must be connected to the
terminal which is marked 'L' or coloured RED. Never connect either of the wires to the big
EARTH terminal marked 'E' or coloured GREEN or GREEN AND YELLOW.
Do not dispose the product in household waste at the end of its useful life. Disposal can
take place at the Remington
100213 REM IFU CB65_21L.indd GB_3 100213 REM IFU CB65_21L.indd GB_3
WIRING INSTRUCTIONS UK Plugs Only

PROTECT THE ENVIRONMENT

® Service Centre or appropiate collection sites.
For further information on recycling see www.remington-europe.com
13A . If in doubt consult a
E
L
N
NEW WIRING
COLOUR CODE
3
01.04.10 12:28 01.04.10 12:28