Insulation Spacer - Panasonic TY-CE42PS20 Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Fitting procedure

5. Preparing the plasma display

Attaching the insulation spacers

Place the front surface of the plasma display on a clean

cloth that has no dirt or foreign objects on it, and follow the

procedure below.

If the plasma display has any protruding parts, take care not

to scratch or damage them.

Remove the four caps from the plasma display using a

Phillips head screwdriver.

Note

• Keep the caps that were removed in a safe place.

(They will be required if you use the pedestal.)

Using the supplied Allen wrench

Allen head countersunk screws

and 4 insulation spacers

caps were removed as shown in the figure on the right.

(Tightening torque: 3 to 4 N•m)

6. Mount the plasma display in the ceiling unit

Engage the upper insulation spacers of the plasma

display with the cutouts of the ceiling-hanging

bracket, and slowly lower the display into place.

While lifting the plasma display slightly, insert the

lower insulation spacers into the holes at the lower

part of the ceiling-hanging bracket.

CAUTION

• If the plasma display is lifted too much, its top part will

become disengaged from the ceiling-hanging bracket.

, mount the supplied 4

, 4 dished toothed washers

at the locations where the