Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Quick Start Guide
Controller overview
Normal display
with chambers without fan (BD,
ED) or with fixed fan speed (FD)
Temperature display accuracy:
incubator BD = 0.1 degrees
drying and heating ovens ED, FD =
1 degree
Heating active
Timer operation
Overtemperature alarm
of the safety controller
Standby mode
Lifting and transporting the chamber
Do NOT lift or transport the chamber using the door handle or the door.
Lift the chamber size 56 and 115 with the aid of 2 people
Lift the chamber size 260 with the aid of 4 people at its four lower corners.
Lift the chamber size 720 using technical devices (fork lifter). Set the fork lifter only from the rear in the middle
of the chamber. Make sure to place all the lateral supports of the chamber on the forks.
Transport the chamber only in its original packaging.
Secure the chamber with transport straps for transport.
Normal display
with chambers with adjustable fan
speed (BF, FED)
Temperature display accuracy:
incubator BF = 0.1 degrees
drying and heating ovens FED
= 1 degree
Navigate and
Select the
enter the values
parameter and
confirm the
entered value
BD / BF / ED / FD / FED (E3)
Display in standby mode with
standby symbol
Return to pre-
Change to
ceding level or
standby mode
Normal display
when pressed for
3 sec. To activate
the display, press
again 3 sec
Page 4
Publicité
Table des Matières
