Samsung RS7 Série Mode D'emploi page 18

Reattaching the Fridge Door
1. Insert the lower hinge
hinge bracket 2 .
2. Fit the hole in the corner of the fridge door
over the lower hinge
3
4
3. Insert the upper hinge shaft
on the hinge . Make sure the hinge is level
6
between the upper hinge hole
the top of the cabinet
screws and the ground screw
9
in a clock wise direction.
4. Place the front part of the upper hinge cover
on the front of the upper hinge
with the screw.
11
DA68-02710R-12.indb 18 DA68-02710R-12.indb 18
1 back into the lower
1
2
3
.
4
into the hole
5
and the hole on
7
. Then, reattach hinge
8
by turning it
10
11
and reattach it
12
12
English - 18
Reattaching the Water Supply Line
2
1. Insert the water line into the coupler
2. The Water Line must be fully Inserted to the center
of transparent coupler to prevent water leakage
from the dispenser.
3. Insert the 2 clips in the install pack and check that
each clip holds the line fi rmly.
clip A (1/4 in.) clip A (1/4 in.)
(6.35 mm) (6.35 mm)
Do not cut the water line.
Gently separate it from the coupler.
Reattaching the Front Leg Cover
Before attaching the cover, check water
connector for leakage.
Replace the front leg cover by turning the three
screws clockwise, as shown in the fi gure.
.
1
1
2
Center of transparent Center of transparent
coupler coupler
2016. 6. 22. 2016. 6. 22. 9:18 9:18