Campbell Hausfeld/Scott Fetzer CP5211 Mode D'emploi page 17

Troubleshooting Guide
syMPtoM
Pressure washer does not
start up
Motor stops suddenly
Unit begins to smoke
Pump noisy / pump runs
rough
Pressure washer will not spray
detergent
CAuse
1. GFCI has tripped
2. Plug is not well connected or electric
socket is faulty
3. Extension cord too long or wire size
too small
4. Main voltage supply too low
5. Thermal safety switch has tripped
1. Extension cord too long or wire size
too small
2. Thermal safety switch has tripped due
to overheating
Overheated, overloaded or damaged
motor
1. Pump drawing in air/low water supply 1. Ensure fittings are tight. Increase water pressure
2. Valves dirty or worn
3. Worn bearings
4. Water too hot
1. Not using soap tip
2. Clog, kink, or hole in detergent
suction hose
3. Hose length too long
4. Lance not functioning properly
Models CP5211, CP5216 and CP5321
solutIon
1. Push reset button on plug
2. Check plug, socket and fuses
3. Remove extension cord
4. Check that main supply voltage is adequate
5. Switch off unit and allow motor to cool down
1. Remove extension cord
2. Check that main supply voltage corresponds to
specifications
Turn off unit and call 1-800-330-0712
2. Check, clean or replace
3. Check and replace
4. Reduce temperature below 100° F
1. Install 65 degree (black) soap tip
2. If clean, unkink or replace hose.
3. Use only hose length provided with initial
purchase of pressure washer. Detergent suction
will not function if more than one section of hose
is attached to unit.
4. Remove lance from gun. If detergent is dispensed
through gun, the lance must be replaced. If no
detergent is dispensed through gun, remove 1"
tapered detergent barb from pump. Clean the
barb, and make sure that ball and spring are
properly aligned with tapered portion of the
spring facing the ball. The ball should be on top of
the spring.
www.chpower.com 17 17