Lorex L23WD Série Mode D'emploi page 151

Configuring a DMZ host connection
• Connect to "Router 1" on your network (referred
to as "Possible 1st Router" in the Auto Port
Forwarding Wizard). Obtain the IP address of
Router 1. Usually this can be found in the
"Status" section of your router menu. The IP
should begin with "192.168...."This IP address is
your DMZ IP.
• Enter the IP address obtained from Router 1 into
the DMZ section of Router 2.
• Once you have configured Router 2 with a DMZ
connection, run the Auto Port Forwarding
Wizard to begin auto port forwarding to Router 1.
• Consult your router's owner's manual for details
on configuring DMZ settings.
Locating your Router IP - The Status Page Locating your Router IP - The Status Page
The "Status Page" of a router normally includes the router's
vital information such as the IP address.
EXAMPLE
Figure 28.12 Router status page.
Lorex Auto Port Forwarding Wizard
Example
DMZ stands for Demilitarized Zone. Enabling a DMZ
IP on your router enables one of the routers to pass
information onto the second router.
Figure 28.11 Entering DMZ information.
The IP information is
normally under a
header called "WAN" or
"Internet Port". Each
router has different
terminology.
Router IP assigned by
the main router. Enter
this IP into the DMZ
section of the primary
router.
DMZ IP address
assigned by a
secondary router
133