Preparing The Unit - Sony IPELA NSRE-S200 Manuel D'installation

Preparing the Unit

Use the supplied fasteners and screws to install the inner
rail on the unit.
1
Use the supplied flat head screws to attach the
mounting ears to the front of the side panel.
2
Use the remaining supplied round head screws to
install the rails to the unit, as illustrated.
Green tab
Caution
Using screws other than the supplied screws may
damage the unit. Be sure to use the supplied screws
to install the rails.
Preparing the Rack
Install the rails on the rack.
1
Determine where you want to install the rails on the
rack.
We recommend marking this position with a
marker or felt tip pen.
Caution
Rails installed at different heights could result in
unit malfunctions.
10
Installation
Mounting ear
Flat head
screws
Rail
Round head
Green tab
screws
2
Install the rails on the rack.
(1) Adjust the length of the rails to match the length
of your rack.
(2) Use the supplied truss screws and washers to
secure both ends of the rails to the rack.
Mounting the Unit on the Rack
Insert the unit into the rack, and then secure it.
Caution
At least two people are needed in order to handle the unit
to prevent personal injury.
1
Pull the sliding rails from the rail assemblies.
Truss
screws
Washers