Product Description; Product Overview; Important Safety Information - OKBABY Orion Manuel D'instructions

Front mounted child bike seat
EN
OKBABY ORION
Read the instructions and keep them for future reference.
Follow and comply with the safety precautions!
Make sure you know how to mount and use the Orion child seat before
using it.

Product description

Orion is a front seat that is mounted on the bicycle frame head tube
with a round section diameter of between 32 to 52 mm. Orion is de-
signed for carrying children who are at least about 9 months old and/or
who have a minimum weight of 9 kg, and up to a maximum of 15kg.

Product overview

1 Seat
2 Padding (fixed with Velcro system)
3 Safety belts
4 Footrests with their respective straps
5 Bumper bar
6 Support arm
7 Fastening block
8 2 U-shaped brackets
9 2 plastic covers
10 2 M6x20 screws and their respective nuts with toothed washers
11 Set of five reductions for different sized bicycle frames
12 Seat fixing plate
13 2 closing caps and relative M5x50 screws with M5 nuts (when the
bumper bar is to be removed)
14 Hexagon ring wrench
15 2 rotating pins
16 4 M6 hexagonal flanged nuts
17 2 screw casings

Important safety information

1) The Orion child seat must be mounted between the handlebar and
the driver on the bicycle head tube, as shown in this manual (Il-
lustration 10). Do not tighten the screws excessively and check the
tightness periodically.
2) Check that the bicycle is suitable for adding supplementary loads.
Check the information supplied along with the bicycle or ask for
information and advice from the bicycle manufacturer.
3) Adjust the seat and its components in order to give the child the
most comfort and safety. When the child is in the seat, the backrest
should be slightly tilted backwards, so as to prevent the child from
sliding forward.
6 Front mounted child bicycle seat Okbaby Orion
4) Check to ensure that each part of your bicycle is working properly
with the seat mounted.
5) Check the existence of any laws present in your State that govern
the use of child bike seats.
6) The Orion child seat is designed for carrying children who are at
least about 9 months old and/or who have a minimum weight of
9 kg, and up to a maximum of 15kg. The child must be able to sit
independently, at least for the duration of the ride.
7) Check initially and then periodically that the weight and size of the
child does not exceed the maximum allowed by the seat.
8) Check that the child or part of his clothes do not come into contact
with moving parts of the seat or bicycle.
Avoid the child's hands and feet coming into contact with the wheel
or being caught in the brakes.
9) Ensure that there are no sharp edges that could come into contact
with the child.
10) Ensure that the safety belts are not loose and do not come into
contact with the moving parts of the bicycle, especially with the
wheels, even when the child is is not being carried in the seat.
11) Always use the safety belts. Make sure your child is properly se-
cured with the seat belts.
12) The child in the seat must be clothed and protected from the cold
more than the person riding the bicycle. Protect the child from rain.
13) It is advised to make the child wear an approved protective helmet.
14) Check that the seat is not too hot (e.g., overheated by the sun)
prior to placing the child in it.
15) Remove the seat when the bicycle is transported by car. Strong
wind could damage the seat or detach it from the bicycle, causing
accidents.
16) Before each use, check the seat is fitted onto the fastening block
correctly: on pulling the support arm upwards, the fastening block
must hold the seat down firmly.
17) The seat material (polypropylene) loses some of its mechanical
properties with ageing if exposed for longer periods to environ-
mental conditions (sun, rain, ice, etc.). In the case of normal use
and exposure to environmental conditions, the seat should be
replaced after 3 years.
Warnings
1) WARNING: Do not place any additional baggage on the seat. Any
additional baggage must be placed on the opposite side of the bi-
cycle with respect to the seat. For example: if the seat is in the rear
of the bicycle, use a front bag carrier and vice versa.
2) WARNING: Do not modify the seat.
3) WARNING: The ride of the bicycle may be different with a child in
the seat, especially regarding the balance, steering and braking.
Front mounted child bicycle seat Okbaby Orion 7