Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Adjusting a cutter
S et the planing depth to 0.
T urn the screws in or out to determine the
correct adjustment. The cutter is properly
adjusted when the cutting edge touches the
surface of the workpiece.
Setting the planing depth (fig. 5)
T urn the adjustment knob (4) until the desired
planing depth is reached.
Instructions for use
C lamp the workpiece.
M ake sure that the knives has reached full
speed before they touch the workpiece.
G uide the machine at a constant speed
across the material to be worked. Do not guide
the machine across the workpiece too fast.
Allow the machine enough time to plane the
workpiece.
H old the machine with both hands using both
grips. This ensures optimum control over the
machine.
F or large surfaces it is recommended to make
several shallow cuts at a smaller planing depth.
T ake the machine from the workpiece after
use before switching off.
P lace the machine onto the parking shoe
when putting the machine down.
Switching on and off (fig. 5)
T o switch the tool on, keep the lock-off button
(2) depressed and press the on/off switch (1).
T o switch the tool off, release the on/off switch
(1).
CLEANING AND MAINTENANCE
The machine does not require any special
maintenance.
R egularly clean the ventilation slots.
TECHNICAL DATA
Mains voltage
Mains frequency
Power input
No load speed 1
Planing width
Max. planing depth mm
Weight kg
LpA (sound pressure) dB(A)
LWA (acoustic power) dB(A)
protection of hearing.
Weighted root mean square acceleration
value according to EN 60745-2-14: < 2.99 m/s²
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
ENVIRONMENT
Should your machine need
replacement after extended
use, do not put it in the
domestic waste but dispose of
it in an environmentally safe
Made in China
230V
50Hz
450W
15,000min
82mm
0.6
2.5
85.7
96.7
Take appropriate
measures for the
way.
2010
8
Publicité
Table des Matières
