Safety Instructions; Electrical Safety - Elem Co-Ligne RE801-G Mode D'emploi

WARNING
Read this manual carefully
before using the machine, for
your own safety.

SAFETY INSTRUCTIONS

When using the machine, always observe the
enclosed safety instructions as well as the
additional safety instructions.
ADDITIONAL SAFETY INSTRUCTIONS FOR
PLANERS
B efore using the tool, make sure that the

cutters have been properly mounted.
Do not use the tool before it has been fully
adjusted according to the instructions.
B efore planing, let the tool run without load to

check if the cutters are properly balanced.
N ever load the tool so much that the motor is

coming to a standstill.
W hen planing, shavings may assemble in the

grooves. Do not remove the shavings with your
hands - use a piece of wood.
O nly use the cutter cylinder and cutters

supplied with the tool.
U se original accessories only.

O nly use sharp cutters.

I f you want to make adjustments to the tool,

switch it off, wait for the cylinder to come to a
standstill and unplug the tool.
S witch off the tool and wait for the cutters to

come to a standstill before putting the tool
down. Reduce the planing depth to avoid
contact between the cutters and other objects.

ELECTRICAL SAFETY

Always check that the power supply
corresponds to the voltage on the rating plate.
GB PLANER
DESCRIPTION (fig. 5)
Your planer has been designed for planing
wooden workpieces. This tool is not suitable for
stationary use.
1 On/off switch
2 Lock-off button
3 Shavings discharge outlet
4 Planing depth adjustment knob
6 Planing base
7 Parking shoe
Replacing the cutters (fig. 7)
(6) pointing towards you.
visible.
direction as shown.
as shown.
holder with the cutter from
the cylinder, into the direction as shown.
the cutter comes loose.
The cutter has two cutting edges. When both
cutting edges are worn, the cutter must be
replaced.
facing upwards or take a new cutter.
holder.
holder with the cutter in the cylinder.
to the direction as shown.
180° and repeat the steps described above.
Always unplug the tool before replacing the
cutters.
P lace the tool on a table with the planing base

R otate the cylinder (8) until the first cutter is

L oosen the screws a few turns, into the

L oosen the bolts a few turns, into the direction

K eep the screening pressed and remove the

D isassemble the parts of the holder so that

T urn the cutter so that the new cutting edge is

P lace the cutter between the parts of the

K eep the screening pressed and place the

R e-adjust the cutter.

F ix the cutter by fastening the bolts, opposed

T o replace the other cutter, rotate the cylinder

7