john deer D100 Série Manuel D'instructions page 8

INSTALL THE FRAME
ASSEMBLY INSTRUCTIONS
1
LR
M
LL
Locate right and left front upright parts [LR, LL] and front rib [M]
3
LR
Insert the front rib [M] into the stub tube found near the bottom of the front
uprights [LR, LL]. Secure by inserting the rib into the front upright stub tubes until
the spring push buttons click into the holes.
5
NL
Line up the back uprights [NL, NR] so that the spring push buttons in the bottom
ends match up with the holes in the receiver tubes on the rear mounting bracket
[H]. Insert the back uprights into the receiver tubes until the spring push buttons
click into the holes. Repeat on the other side.
LL
M
NR
H
2
Locate right and left rear upright parts [NR, NL].
4
Insert the short tube ends of each front upright [LR, LL] into the protruding tubes
found on the front mounting bracket [B] already installed on the mower. Make
sure that the spring buttons in the short tubes on the front mounting brackets
click into the holes in the ends of each front upright.
6
When properly installed the rear
mounting bracket and the uprights
should flare back and to the rear of
the riding mower.
8
D100 SERIES AND S200 WEATHER ENCLOSURE
NR
NL
B