john deer D100 Série Manuel D'instructions page 13

INSTALL WEATHER ENCLOSURE SHELL CONTINUED...
18
Fender Deck
Edge
WARNING
This step helps seal the weather enclosure against the entrance
of carbon monoxide gas. Breathing carbon monoxide gas can
cause unconsciousness or death. Follow this step closely.
20
Fender Deck
Start on the bottom front left side of the shell, find the 5" long plastic clip sewn
near the hem. Pull this clip down and hook under the edge of the riding mower
fender deck making sure to trap the woven material between the inside of the
hook and the edge of the fender deck. Repeat on other side.
22
Verify magnets align with the fender deck when the door is closed.
Shell Fabric
Trap the fabric
flap between
the clip and
Clip
fender deck
CORRECT
ALIGNMENT
Bottom Hem Magnets
19
Front Clips
Clip locations.
21
At the back of the shell there is a 17" long plastic clip. Hook the clip under the edge of
the fender deck, making sure to trap the shell fabric between the inside of the clip and
the rear edge of the fender deck. (See step 18 for detail)
23
Installation complete.
13
D100 SERIES AND S200 WEATHER ENCLOSURE
Back Clip