john deer D100 Série Manuel D'instructions page 12

INSTALL WEATHER ENCLOSURE SHELL CONTINUED...
ASSEMBLY INSTRUCTIONS
12a
E1
D1
C1
Locate parts [C1, D1, E1] to secure the
enclosure shell.
14
Secure front mounting clevis pins [C1] with M6 Fender Washers [D1] and
hitch pin clips [E1].
16a
At the bottom front of the weather enclosure shell, find the stretchable material
skirt. You will notice a hole in the fabric near the bottom on either side. Fold the
outside part of the fabric in toward the mower and slip the hole over the foot
controls on either side.
12b
Grommets
Locate the two grommets at the front
of the enclosure shell [U]
B
E1
D1
16b
13a 2
C1
Working inside the engine cowling area of your riding mower, insert the front
mounting clevis pins [C1] through the holes in the fabric flap on the front of
the shell. Then insert the clevis pins [C1] up through the holes on the mounting
bracket [B].
15
Secure the shell to the frame by using pre-attached rip-and-grip strips sewn into
the inside of the shell. Wrap the straps around the roof ribs [P1, P3] the front
horizontal rib [M] and back [NL, NR] frame uprights and secure.
17
Attach the stretchable material skirt to the rip-and-grip strips installed in the
engine cowling area. Close mower hood. Be careful not to get any shell material
caught or pinched when closing.
12
D100 SERIES AND S200 WEATHER ENCLOSURE
13b
D1
B
U
E1
B
C1