Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Use
Figure 2
1.
Click the hose connector into the hose opening on the motor unit. To remove
the hose, press on the two release buttons on the side of the connector and pull
the connector from the opening; see Figure 2.
A
Figure 3
2.
Slide the telescopic tubes onto the hose handle, see Figure 3A.
3.
Press the button on the telescopic tubes and keep it pressed in; you can then
extend or retract the tubes to the required length. See Figure 3B.
Figure 4
4.
Press the foot button on the nozzle to set the combi nozzle for use on hard or
soft surfaces, see Figure 4. For use on hard surfaces, press the foot button on
the combi nozzle to extend the brushes. Lift the button for use on soft surfaces.
Fitting the hose to the connector
B
Adjusting the length of the telescopic tubes
Soft and hard surfaces
Publicité
Table des Matières
