Using The Input And Output Connectors - Sony BKM-244CC Mode D'emploi

Using the Input and
Output Connectors
For information about installing the BKM-244CC
in an input option slot on the main unit, see the
operating instructions for the main unit.
Configuration of Input/Output
Connectors and Signals that may be
Input
The configuration of the input and output
connectors, and the signals that may be input
are shown below.
1
1 2
INPUT
1 Input serial digital component signals.
2 Output serial digital component monitor
signals.
Input of serial digital component
signals
You can input serial digital signals to
connectors 1 and output signals displayed on
the screen of the main unit or the monitor from
connector 2.
You need not attach the 75-ohm termination to
connector 2.
Notes
• The MONITOR OUT signal is output only
when the power of the main unit is ON. The
MONITOR OUT signal is not output when
the monitor is in standby mode.
• The MONITOR OUT signal does not
comply with ON-LINE signal specifications.
2
BKM-244CC
DIGITAL/HD SDI
MONITOR OUT
Using the Input and Output Connectors / Specifications
Specifications
General
Voltage +3.3 V, +5 V (supplied from the
main unit)
Power consumption
Approx. 4 W
Operating conditions
Temperature
0 °C to 35 °C (32 °F to 95 °F)
Optimum temperature
20 °C to 30 °C (68 °F to 86 °F)
Humidity 0% to 90% (no condensation)
Pressure 700 hPa to 1060 hPa
Storage and transport conditions
Temperature –10 °C to +40 °C (14 °F to 104
°F)
Humidity 0% to 90%
Pressure 700 hPa to 1060 hPa
Maximum external dimensions (w/h/d)
100 × 20 × 162 mm
(4 × 13
Mass Approx. 250 g (9 oz)
Input/Output connectors
Digital input
BNC (2), with monitor output
connector
Available signal format
Refer to the Operating Instructions of the multi
format main unit.
Signal characteristics
Digital component signals
Sampling frequency
D1-SDI: Y/R-Y/B-Y: 13.5 MHz
HD-SDI: Y/P
Quantization
10 bits/sample
MONITOR OUT
Output signal amplitude:
800 mVp-p ± 10%
Output impedance:
75-ohms unbalanced
Transmission distance
D1-SDI: 200 m (approx. 656 ft) max.
(When using 5C-2V coaxial
cables (Fujikura. Inc.) or
equivalent.)
HD-SDI: 100 m (approx. 328 ft) max.
(When using 5C-FB coaxial
/16 × 6 1
/2 inches)
/P : 74.25 MHz
B R
7
GB