Ayce XE-9S Manuel D'utilisation page 22

LIST OF MAIN PARTS :
Installation
1. To prevent damage, place the radiator upside down on a soft surface (for example a
carpet)
2. Fix wheels on two plates with cap nuts. Wheels should be installed between the two
first and two last fins.
3. Insert the U-shaped hook into the wheels plate and fix it on the radiator by wing
nuts.
4. Turn the heater upright. Wait one minute before to connect the heater to power
outlet.
Fig. 2
1 Wheels
2 Mode button
3 LED display
4 ECO button
5 Radiator housing
6 Power switch
Fig. 1
OPERATION:
1. Plug the appliance to AC 220-240V 50/60 Hz socket
2. To start the heater, press the ON/OFF button
3. Rotate the MODE to select the target temperature from Fr-5-35ºC,
When the setting temperature is lower than 5ºC, the equipment will
work in anti-frost function, the screen will display
4. Press button to start the power setting, then rotate the
set the power as H1-H2-H3. Press
Setting H1
Power 800 W
5. Press MODE for 3 seconds to set the timer off : 1 hour-24 hours, set 0 hour to turn
off the timer function
6. This heater with Economic mode, press
work automatically based on the ECO program.
Example: the LED display will show
the target temperature is 20ºC.
7. To stop the heater working, turn the power switch to OFF position
8. Unplug the product when it's not in use
TIP-OFF SAFETY DEVICE:
This appliance is provided with a safety device which will switch off the heater in case of
accidental tipping off. To reset, disconnect the plug from the power for a few minutes,
remove the cause of tipping off, then plug the appliance in again. If it still cannot be
reset, ask a qualified technician to check and repair.
OVERHEAT SAFETY DEVICE:
Your heater is fitted with a safety device to switches off the heater in the event
of overheating. If the safety device operated, please turn the heater off, unplug
the appliance and let it completely cool, inspect for blockage of air inlet or outlet,
attempting to restart the heater then after.
If the heater fails to operate or the safety device switches the heater off again, return
heater to your nearest service center for examination or repair.
42 | 43
.
to
again to finish the setting.
H2 H3
1200 W 2000 W
to activate the function, the heater will
when you activate the ECO funtion when
GB