Axion STIM-PRO X9+ Manuel D'utilisation page 42

STIM-PRO X9+
Steps to select a program (P)
Select P mode with
In program mode you can choose between 37 different
EN
programs for various areas of application. These are fully
pre-programmed - just set the intensity for the connected
channels and start the application!
The program starts immediately when you set the intensity!
Most programs run in continuous mode, recognizable by
a "C" shown in the lower right corner of the display. Some
programs also have a pre-defined duration. The device ends
the application automatically when the time expires. Please
use these programs for the pre-defined duration only and
do not extend or shorten the duration of the application.
To set a program, press the „MODE"
button until you reach P mode,
recognizable by a P shown in the
bottom-left corner of the display.
Press or to select the
desired programs (P1 – P37). You find
an overview over all available
programs on pages 42 to 46.
When you chose the right program, please set the intensity
for the connected channels (1-4).
Increase intensity
Decrease intensity
In P mode, the parameters are set by default and can not
be changed!
41