Fcc Statement; Declaration Of Conformity - HP df730v1 Manuel De L'utilisateur

FCC Statement

FCC Part 15 Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the Federal Communication Commission (FCC) Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation
If this equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encourages to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
!
Warning: Changes or modification to this unit nor expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.

Declaration of Conformity

Supplier's Name:
Supplier's Address:
Product Name and Model: Hewlett Packard Digital Picture Frame
Regulatory Model number: (1) df730v1 (2) df840v1 (3) df1010v1
Conforms to the following product specifications:
EMC:
EN 55022: 2006 + A1:2007
EN 61000-3-2: 2006
EN 61000-3-3: 2008
EN55024:1998 + A1:2001 + A2:2003, Class B
EN 60950-1: 2006
FCC part 15
VistaQuest Corporation
6320 Canoga Avenue, 15
th
Floor, Woodland Hills California 91367, USA
19