Assembly; Fitting The P-Barrier; Assembling And Dismantling The Two-Piece Shaft - McCulloch B26PS Manuel D'utilisation

Fitting the P-barrier

Clip the loop handle with the P-barrier onto the shaft. Note
that the loop handle must be fitted between the arrows on
the shaft.
• Fit the bolt, securing plate and wing nut as shown in
the diagram. Tighten the wing nut.
Assembling and dismantling the
two-piece shaft

Assembly:

• Loosen the coupling by turning the knob.
• Align the tab of the attachment (A) with the hole in the
coupling (B).
B
A
ASSEMBLY
• Push the attachment into the coupling until the
attachment snaps into place.
• Before using the unit, tighten the knob securely.
Dismantling:
• Loosen the coupling by turning the knob (at least 3
times).
• Push and hold the button (C). While securely holding
the engine end, pull the attachment straight out of the
coupling.
C
English
–
11