International Symbols; Assembly Instructions; P" Handle Assembly; Debris Shield - McCulloch MCT3362VA Mode D'emploi

2 - SAFETY PRECAUTIONS

2-3. INTERNATIONAL SYMBOLS

Minimum operating distance
Use of these personal safety items is highly recommended to
reduce the risk of accidental injury.
Read the User Manual.
Do not use blade on this unit.
Pump the primer bulb 10 times.
6

3 - ASSEMBLY INSTRUCTIONS

3-1. "P" HANDLE ASSEMBLY

1. To install handle onto unit, you will need the following
components from your user kit: "P" handle (A & B),
screws (C) and nuts (D). (Figure 3-1).
2. Install the handle (B) on the shaft 6.0" to 7.87"
200mm) from throttle and tighten the 2 screws (C) and
nuts (D).
A
C
B
D
3-1A

3-2. DEBRIS SHIELD

WARNING
The debris shield must be installed (Figure 3-2A) to prop-
erly dispense cutter line and protect operator.
Shield fits snug on shaft. Some force may be required.
1. Seat shield (A) onto shaft bracket (B). (Fig. 3-2A)
2. Insert bolt (C), washer (D), lock washer (E) and wing
nut (F), tighten securely. (Fig. 3-2B)
B
A
3-2A
F
E
D
(160-
3-2B
7
C