Auxiliary Connections - Visonic VGSM-120 Mode D'emploi

Auxiliary connections

The auxiliary connections are not necessary for the Communicator operation, but they maximize the versatility
of this device. These connections are described in the following paragraph.
Tamper - The connection of the MAXIASNC tamper switch (optional) allows you to detect the Communicator
cover opens. The tamper switch wires can be connected as follow.

To the panel tamper line or a different 24h zone. Read the panel instructions for more information.

To terminals [ T3 ] and
telephone numbers, when the

Communicator cover is removed.
The second solution requires to program the Communicator by the VGSM-120 Console, as indicated in the
Programming the device->Optional Tamper Programming section). After connecting the MAXIASNC
tamper switch and programming the Communicator, close the cover and power up. After the initialization of the
Communicator, open the cover and check that the SMS and/ or Voice message has been sent to the programmed
telephone numbers.
D-305708 VGSM-120 Installation Instructions
of the VGSM-120, to send a SMS and/or Voice message, to one or more
9