Apn1 Username And Password, Apn2 Username And Password; Telephone Numbers To Decode; Dnis; Account Code - Visonic VGSM-120 Mode D'emploi

APN1 Username and Password, APN2 Username and Password

Some providers may require a user name and password to validate communication. If needed, enter this
information here. APN2 Username and Password are considered to be backup data.

Telephone numbers to decode

This communicator permits communicating the events in the Contact ID format, via the GPRS network,
also to the control panels that do not support this communication method.
To do this, you must setup a telephone number (the phone numbers can be "virtual" or "real") on the control
panel for event communication in Contact ID format (e.g. you can setup 0123), then you must enter the same
telephone number in one of this fields (you can program up to four telephone numbers for this function).
When the Communicator recognizes a call from one of these numbers, automatically transcodes the
event in digital format and forwards it on the GPRS network to the set receiver (refer to the "Main
Receiver" and "Backup Receiver" options).
Note: The telephone number must be of at least 2 digits.
The options "Prefix" and "Digits to remove" have no effect on the "Telephone numbers to
decode".
The "Telephone numbers to decode" must exactly match with the telephone numbers set for
the control panel. Leave these fields empty if you don't use this function. For this feature to work
correctly, the "Main Receiver" (and, where necessary the "Backup Receiver") option must be
selected.

DNIS

If required, enter the Dialed Number Identification Service number.

Account code

The account code for communication with Sur-Gard System III or System II receivers must be entered in this
box.
Note: Ensure a different Customer Code is assigned to each communicator that transmits events to the
same receiver.

Enable Supervision

To enable supervision, select this option. The supervision option is ONLY available to the main receiver.
The supervision messages are not sent when the device is performing a voice call (on GSM).

Supervision time (sec)

Set the Supervision time for the monitored receivers. It is possible to set a Supervision time between a
minimum of 5 second and a maximum of 65535 seconds, with steps of 1 second.

Status

This page will allow you to monitor and control in real-time all the Communicator functions.
ATTENTION: This page is updated every 5 seconds.

Status section

This section lists the most important data relating to the GSM module. The virtual display shows, in addition to
the name of the GSM network manager, the GSM signal strength (this is displayed through a special indicator).
The Device status indicator may be ON or OFF .The Device status indicator light when it is GREEN: proper
function. When it is RED, this indicates that there is no communication between the software and the device; if it is
ORANGE it means that there is a communication in course. For GPRS Main Receiver and GPRS Backup
Receiver this indicator is ORANGE when the Receiver is initialized but NOT currently connected OR connected
but NOT yet initialized.
D-305708 VGSM-120 Installation Instructions 23