IKRA ESF 4016 Manuel D'utilisation page 17

Safety Precautions
1. This machine is to be used exclusively
- as rotary snowplough for clearing snow from sur-
faced paths and the grounds of houses and leisure
areas.
- in accordance with the descriptions given in these
operating instructions and safety instructions.
2. Any other usage is considered to be contrary to regu-
lations!
3. Usage of the machine contrary to regulations or arbi-
trary alterations of the machine cause the liability of
the manufacturer to become invalid.
4. The user is liable for any damage to a third party or
the property of a third party caused by the operation
of the machine.
5. As machine user you should read these operating in-
structions with care before using the machine for the
first time. Work according to them and take care of
them for later reference or in the case of a new owner.
6. The machine must not be operated by persons under
the influence of intoxicants such as alcohol, drugs or
medication.
7. Do not permit any person under the age of 16 to use
this machine (the minimum age for usage can be
regulated differently in different areas).
8. Keep persons, in particular children and pets away
from the machine.
9. Never operate the machine indoors but always only in
the open. Overbuilt and high-walled paths may only
be cleared when safe operation is possible. Pay par-
ticular attention to windows and persons in the prox-
imity in order to exclude injury to persons and dam-
age to property.
10. Never direct the machine towards persons.
11. Do not use the snowplough near glass, motor vehi-
cles, windows etc. without correctly adjusting the an-
gle of the snow ejector.
12. For the work or for maintenance always wear gloves,
safety glasses, tight-fitting winter clothes and strong
shoes with profiled soles.
13. Never allow body parts or clothing near rotating ma-
chine parts.
14. Use the machine only where there is sufficient light.
Always hold the machine and the handles tightly.
Never run with the machine.
15. Use the machine only for light, loose snow (new
snow) up to a maximum depth of about 20 cm.
16. Frozen snow and ice must not be cleared with this
machine.
17. Allow the motor to cool down before storing in an en-
closed room.
18. Operate the machine only in faultless condition as es-
tablished by the manufacturer and delivered.
19. Use only original spare parts from the manufacturer
or parts from a different supplier but approved by the
manufacturer.
20. Allow the machine to be repaired only at a qualified
workshop.
21. Do not make adjustments while the machine is run-
ning (unless the adjustments are recommended di-
rectly by the manufacturer).
22. The safety gap to the rotating parts defined by the
guide bar must always be assured.
23. Stop the motor before moving it over surfaces such
as pavements or yard entrances which should not be
cleared. Operate the machine always only in a fault-
less and safe condition.
24. Check the area to be cleared and remove all objects
which could be taken up and ejected by the machine.
25. Possible damage to the machine: When foreign
bodies (e.g. stones) strike the machine or unusual
vibration occurs, switch off the machine and check
for damage. Repair any damage before working any
more with the machine.
26. Operate the machine only in faultless condition. Make
a visual inspection each time before starting up. In-
spect for damage in particular the safety components,
electrical operating elements, electrical wiring and
screw connectors for tightness. If necessary replace
damaged parts before operating.
27. In case of extreme temperature differences, please
allow the rotary snowplough a short time to adjust to
the ambient temperature before beginning to clear
snow. Otherwise, by beginning immediately with the
work, early wear on the drive shaft and other compo-
nents, for example rubber seals can take place.
28. Work slowly and carefully, particularly when changing
direction. Direct the machine against the gradient or
with the gradient, but not across it. Watch out for hin-
drances, do not work near hilly terrain. Never use the
machine on slopes with a gradient more than 20%.
29. Clear snow immediately after snowfall; later the snow
layer beneath turns icy and makes the work difficult.
30. Where possible clear in the wind direction.
31. Clear snow so that the cleared tracks overlap a little.
32. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowl-
edge, unless they have been given supervision or in-
struction concerning use of the appliance by a person
responsible for their safety.
33. Children should be supervised to ensure that they do
not play with the appliance.
Electrical Safety
1. Use only connecting cables (max. 50 m), which are
suitable for outdoor use e.g.
- H07RN-F 3x1,5 mm² down to –25°C
- H07BQ-F 3x1,5 mm² down to –40°C
2. Cable extensions must be protected against water
splashes and made of rubber or covered in rubber.
3. Before use, check each time whether the cable exten-
sions are damaged, brittle or entangled. For this you
must switch off the machine and unplug it. Use only
cables that are in faultless condition.
4. Switch off the motor, unplug the power supply when
you
- are not using the machine
- you leave the machine unattended or
- you do adjustments, maintenance or repair work.
5. For your power supply socket use a personal protec-
tion switch (= faulty current protection switch with a
max. of 30 mA actuator current).
GB-3