Indel B K CELLAR 36 ECOSMART Mode D'emploi page 29

Start-up and use
After inserting the battery, the display remains as follows for 5 seconds.
The display then shows the current time. If no buttons are pressed for the following 8
seconds, all information will disappear from the display until a button is pressed.
If the P1, P2 or P3 button is pressed, the display shows the pre-set programmes as described
below. Please note: programmes P1-P2 and P3 are pre-set and cannot be modified.
Programme P4 enables the user to set two operating cycles for the appliance (Time on1
–Time off1 and Time on2 and Time off2).
To customise programme P4:
press P1 and P4 at the same time.
"Time On1" flashes on the left.
Use the - (P2) and + (P3) buttons to set the start time of the first cycle.
Press the P1 button to pass to the next fields and use the - and + buttons to change the
start and stop times of the compressor operating cycles.
When the customisation is completed, press P4 to save the new settings.
Please note: When the appliance has been used in TIMER mode, to return to STANDARD
mode, P4 must be reset from the remote control, with all values set to 00:00, then press
P4 (see the instructions in the SETTING THE TIME section).
Please note: when the appliance has been used in SMART mode, to return to STANDARD
mode, remove the SIGNAL cable, reset P4 from the remote control, setting all values to
00:00, and press P4 (see the instructions in the SETTING THE TIME section).
OFF SET TIME
TIME
ON 1
TIME
ON 2
27