Babyauto Dun Notice D'instruction page 13

3. HOW TO INSTALL THE CHILD CAR SAFETY SEAT. GROUP 2.
WARNING
1. According to the child's height the headrest can be adjusted up or
down. Place your hand on the headrest and turn the lever
pulling the seat down with the other hand so it does not move (3.1
& 3.2).
2. Place the child seat on the seat of the vehicle, ensuring it is pressed
firmly against the back of the vehicle seat, place the child in the
child car safety seat (3.3).
3. Fasten the belt, ensuring that the lap belt goes through
under both armrests and that the diagonal shoulder belt passes
through B guide and
vehicle anchor point. You will hear a "click" when this is properly
fastened. Ensure that the belts are not twisted and tighten by
pulling the diagonal shoulder belt upwards (3.4, 3.5 & 3.6).
4. HOW TO INSTALL THE CHILD CAR SAFETY SEAT. GROUP 3.
WARNING
It is advisable to continue using the seat backrest until the child's height
exceeds the headboard.
1. Push the backrest back (4.1).
2. Then remove the backrest and detach it from the base as is shown
in Figure (4.2).
3. Place the child seat on the seat of the vehicle, (4.3).
4. Place the child in the child car safety seat (4.4).
5. Fasten seat belt, making sure the lap belt passes under both
armrests and that the diagonal shoulder belt passes under the
armrest closest to the anchorage point. Insert the vehicle safety
belt in the vehicle anchor point. You will hear a "click" when
properly installed twisted (4.5).
Always check that the seat belt is firm and unwrinkled, but that it
does not cause the child discomfort.
Group 2/3
Use Group 2 only from approx. 4 to 6
years of age (15-25 kg)
D guide under the armrest that is next to the
Use Group 3 only from approx. 6 to 12
years of age (22-36 kg)
F while
D guide
D
D
www.babyauto.com
EN
13