Resetting To Factory Settings - Hama 00179807 Mode D'emploi

5.2 FAST SEARCH
1. Press and hold the key [MUTE] and [POWER] until the LED will be lit, then
release keys.
2. Press the key [ CH+]. Each time you press, the remote will search once. When
the code changes, you can test if [POWER], [VOL+], [0-9] keys work
well. If ok ,please press [ MUTE] to save the code and exit.
3. lf it doesn't work well, repeat the fast search by pressing [ CH+].
5.3 CODE INQUIRY
Use the following method to find out which code is currently set:
1. Press and hold [MUTE], then press [POWER] until the LED will be lit,
then release keys.
2. Input [9].[9].[0] with number keys. The LED will flash twice and goes off.
3. Press the number key 1 for the 1st digit of the code. The LED will start to
flash. Count the LED flashes. The number of flashes resemble the code's
first digit. Repeat this procedure for the 2nd and 3rd digit of the code:
2nd digit -> enter 2 -> count LED flashes
3rd digit -> enter 3 -> count LED flashes
lf code number is [0] the LED will not flash.
5.4 Compatible Remote Control Model
Due to too many remote control models, we only Iist some of them below.
lf your remote control is similar to the drawing, the replacement remote can
control your TV (Page 47).

5.5 Resetting to factory settings

Press and hold the [RETURN
status LED flashes three times and then goes out. The remote control is now
successfully reset to the factory settings.
Note
• All keys with learnt codes or all copied keys, as well as all remote control
settings will be deleted.
6. LEARN MODE
This remote control is equipped with a learning function. Thus, you could learn
functions of your original remote to this remote control.
6.1 BEFORE STARTING LEARN MODE
• The batteries in the two remote controls have to be in good condition.
Replace them if necessary.
• Place the remote controls with the infrared diodes so that they point towards
each other.
• Where necessary adjust the height of both remotes so that infrared diodes are
properly aligned.
• The distance between the remote controls should be about 3 cm.
HAMA
ROC1117GRU
Note
• Do not move the remote controls during the learning procedure.
• Ensure that the room is not lit by fluorescents tubes or low energy consumpti-
on lamps since such light sources could interfere with the copying.
• The 2 remote controls must be at least
1 meter away from any light source.
• During learning mode, if no key is selected for more than 15 seconds, the
learning mode will exit automatically or
if no other remote signal is received.
• Each function key will hold only one command. A new command to be
learned will automatically replace the previous one.
6.2 ENTER LEARN MODE
1. Press and hold the [MUTE] and [VOL+] keys for approx. 5 seconds until the
LED will be lit.
2. Enter the code [9] [8] [0], the LED will flash 2 times and then remain on.
3. The remote control is now ready to learn new commands.
] and [0] buttons for about 5 seconds until the
ORIGINAL
ca. 3 cm
5
9