THOMSON WHP3001BK Mode D'emploi page 5

• Put the headphones on and set the volume to the desired level.
• Before using the headphones for the first time, make sure that
the battery is fully charged. Charge the battery for at least 24
hours before the first use.
• Switch off the headphones if they are not being used and put
them back onto the transmitter's charging contacts.
Note
• If you cannot get an optimum signal frequency, press the
Auto-Tune button (5) on the headphones.
• If you cannot get an adequate frequency, change the
frequency channel on the rear side of the transmitter. Then
confirm the corresponding channel on the headphones by
pressing the Auto-Tune button.
• To get the best sound experience with your headphones, you
should set the volume of the sound source (TV, stereo system,
etc.) as high as possible and reduce the volume on the
headphones themselves.
The transmitter will automatically switch off if it receives no audio
signal for approximately 2 minutes, or if the signal from the audio
source is too weak for flawless reception. As soon as the signal
strength is sufficient, the transmitter will automatically switch back
on. The headphones do not switch off automatically.
9. Charging, Fig. 3
• Switch off the headphones.
• Place the headphones in the charging station as shown, and
make sure that the charging contacts of both devices properly
touch each other.
• The green LED (1) lights up. Charging begins automatically.
Note
• To prevent damage to the batteries, always switch off the
headphones when they are not in use.
• Before using the product for the first time, the batteries
should be fully charged. To guarantee an acceptable charge,
the batteries should initially be charged for 24 hours.
Subsequent charging cycles then last approximately 10 hours.
• The batteries will not be charged if the transmitter is off.
10. Troubleshooting
10.1 No sound
• Check that the power supply plug is fully inserted into the mains
socket and the other end is properly connected to the power
supply socket on the transmitter.
• Make sure that the headphones are on.
• The battery in the headphones may have insufficient remaining
charge. Charge the battery.
• Check that your TV, hi-fi system or audio source is switched on
and a channel is correctly configured to send an audio signal.
• Increase the volume using the control on the headphones.
• The connected audio/video device may not be in playback mode.
Please start the playback.
• The output volume of the audio source may be too low. Adjust
the volume accordingly.
10.2 Distortion
• Press the Auto-Tune button.
• Set a different frequency channel (1, 2 or 3). Then press the Auto-
Tune button again.
• The battery in the headphones may have insufficient remaining
charge. Charge the battery.
• Increase the volume using the control on the headphones.
• The distance between the headphones and the transmitter may
be too great. Move the two devices closer together and turn the
headphones in the direction of the transmitter.
• The input level of the audio signal may be too low. Increase the
volume of the audio source.
11. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do
not use aggressive cleaning agents.
12. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating
instructions and/or safety notes.
13. Service and Support
Please contact Hama Product Consulting if you have any questions
about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here: www.hama.com
14. Recycling Information
Note on environmental protection:
After the implementation of the European Directive
2012/19/EU and 2006/66/EU in the national legal system,
the following applies: Electric and electronic devices as
well as batteries must not be disposed of with household
waste. Consumers are obliged by law to return electrical and
electronic devices as well as batteries at the end of their service
lives to the public collecting points set up for this purpose or point
of sale. Details to this are defined by the national law of the
respective country. This symbol on the product, the instruction
manual or the package indicates that a product is subject to these
regulations. By recycling, reusing the materials or other forms of
utilising old devices/Batteries, you are making an important
contribution to protecting our environment.
15. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio
equipment type [00131957, 00131958] is in compliance
with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet
address:
www.hama.com -> 00131957 -> Downloads
www.hama.com -> 00131958 -> Downloads
3