Table des Matières
Publicité
10
1180066-21.indd 10
5
9
17
8
10
18
English
Getting the best results
Hard floors and carpets:
The Max In, Max In Turbo
and Max In motorised floor nozzles (5) detect the type
of surface being vacuumed. The nozzle with the pedal is
set to the type of surface to be vacuumed: Position 1 for
carpets (17) and position 2 for hard floors (18).
Crevices, corners, etc.:
Use the crevice nozzle (8).
Upholstered furniture:
Use the upholstery nozzle (9).
Curtains, lightweight fabrics, etc.:
Use the upholstery
nozzle (9). The suction power can be reduced by pressing
the Max-Min button on the vacuum cleaner or the Min
button on the remote control.
Frames, bookshelves, etc.:
Use the dusting brush (10).
Using Max In nozzles
Max In, Max In Turbo and Max In motorised floor nozzles,
are ideal for both hard floors and carpets. The Max In
motorized nozzle receives power via the tube and hose,
and no additional electrical connections are needed. A
blue light on the nozzle indicates that the brush roller is
turning. If anything should become lodged in the brush
roller, the light turns off.
Note: Do not use the Max In Turbo or Max In motorised
nozzles on fur rugs, rugs with long fringes or pile depths
exceeding 15 mm. To avoid damaging the carpet, do not let
the nozzle stay in one place when the brush is rotating. Do
not pass the nozzle over electrical cords, and be sure to switch
off the vacuum cleaner immediately after use.
2/4/08 4:47:34 PM
Publicité
Table des Matières
