Servicing - Maintenance Of The Ventilator; Regular Maintenance - deville C07832 Mode D'emploi

For sweeping :
•
Remove the deflector :
- Lift the deflector
8).
- Lower the back of the deflector
(Fig. 9).
- To replace the deflector, follow the same steps in
reverse.
•
Carefully check the condition of the appliance, and
more especially smoke-tightness : seals, fixings, and
door and frame.
•
Check the condition of the smoke flue and the
connecting pipe ; all fittings should be in good
mechanical condition and be smoke-tight.
•
Clean the extractor fan inside the hood to get rid of
any dust and if necessary clear the hot air
convection system.
6 – SERVICING – MAINTENANCE OF THE
VENTILATOR
6.1 – Dismantling of the ventilator support (Fig. 10)
- Slightly unscrew the three screws
the joint support
- Remove the 2 fixing screws
- Take the blower out by pulling the grid.
Reassembling the blower.
Proceed in the reverse order to the dismantling
6.2 – Electric diagram (Fig. 1 and Fig. 11)

REGULAR MAINTENANCE

•
Clean the glass with a damp cloth. If necessary, use
a household cleaning product provided it complies
with user instructions. Wait until the stove is
completely cool before cleaning.
•
Periodically clean the secondary air intake :
- Use the vacuum cleaner
and dust trapped between the air guide and the
glazed pane. If necessary, to make cleaning
easier, slide a thin blade or a sheet of stiff card
between the air guide and the pane to free
trapped particles (Fig. 12).
Use the end of some metal object
-
the bottom edge of the damper so as to remove
any soot (Fig. 13).
Any soot or other particles are liable to prevent the
formation of the secondary film of air protecting the
glass from direct contact with the smoke and
ensuring full combustion of the wood.
and pull it forwards (Fig. 7 and
and remove it
and remove
.
of the blower.
to remove particles
to scrape
Cleaning should be done as soon as the glass is dirty
and in any event must be done when the stove is
completely out.
If localized and very obvious traces of soot (Fig. 14)
reappear and spread, the air guide must be
dismantled for more thorough cleaning (Fig. 15) :
. Unhinge the door and lay it flat.
. Remove the 3 screws.
. Remove the air guide A and clean it.
. Reinstall the assembly and check that the
recommended play on the pane is complied
with.
This operation must be performed by a qualified
professional servicing agent.
•
Make sure the catch-bolt on the door works
properly ; if necessary, adjust as follows (Fig 16) :
- To tighten the catch:
. Loosen screw
. Give both screws a quarter turn and repeat if
necessary.
N.B : This will increase the pressure of the sealing
strip around the door.
- To slacken the catch :
. Loosen screw
. Give both screws a quarter turn and repeat if
necessary.
N.B. : This will reduce the pressure of the sealing
stop around the door.
•
Clean the hot air grilles in the hood at regular
intervals. How often you do this depends on the
grilles : the smaller the holes, the quicker they get
clogged up.
-14-
and tighten screw .
and tighten screw