Dell 1800MP Manuel De L'utilisateur page 19

2
TEMP warning light
3 Source
4 Keystone adjustment
5
Resync
6
Menu
7
and buttons
8
Enter
9
Keystone adjustment
10 Up
and
11 LAMP warning light
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
18 Using Your Projector
• A solid orange TEMP light indicates that the
projector has overheated. The display
automatically shuts down. Turn the display on
again after the projector cools down. If the
problem persists, contact Dell.
• A blinking orange TEMP light indicates that a
projector fan has failed and the projector
automatically shuts down. If the problem
persists, contact Dell.
Press to toggle through Analog RGB, Composite,
Component-i, S-video, and Analog YPbPr sources
when multiple sources are connected to the
projector.
Press to adjust image distortion caused by tilting
the projector. (±15 degrees)
Press to synchronize the projector to the input
source. Resync does not operate if the on-screen
display (OSD) is displayed.
Press to activate the OSD. Use the directional
keys and Menu button to navigate through the
OSD.
Press to adjust the OSD setting.
Press to confirm the selection item.
Press to adjust image distortion caused by tilting
the projector. (±15 degrees)
Down Press to select the OSD items.
If the LAMP light is solid orange, replace the
lamp. If the LAMP light is blinking orange, the
system has failed and the projector will
automatically shut down. If this problem persists,
contact Dell.