Num'axes CANICOM 5.500 LE Guide D'utilisation page 24

3. Receiver collar in position "deactivated" (indicator light off): move the remote control towards the collar so
that the magnet position indicator comes into contact with the
seconds (Ref. Diagram 6). The indicator on the collar lights in fixed green then flashes in red.
4. Move the remote control away from the receiver collar.
5. Press the vibration button
your remote control.
If you have several collars, renew the same procedure for each one.
Reprogram a receiver collar
●
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a new remote
control from the CANICOM 5 LE range (Ref. Coding procedure).
● How to use the remote control
The CANICOM 5.500 LE remote control is designed to operate with 1 or 2 receiver collars.
The CANICOM 5.1000 LE remote control is designed to operate with 1 or 2 receiver collars.
Before sending any training instruction (beep sound, vibration or static stimulation), you have to select the dog
you want to send a message to.
In order to select the dog, use the
LCD screen.
● button: beep sounds
If you press the button, the receiver collar will emit beep sounds. There is no time limit for this function: the
collar will continue to beep for as long as the button is pressed.
It's up to you to use the beep sounds depending on the way you want to train your dog.
With the beep sounds you can:
- send a warning to your dog when he is disobedient,
- draw his attention ...
It's very important to always use the beep sounds in the same way in order not to disturb your dog.
Gb - 24
of the remote control. The collar emits vibrations; it is then synchronized with
or button of the remote control: the symbol
‹ ›
symbol located on the receiver collar for 6
or appears on the