Correct Attachment & Setting; Instructions; Regular Checks - Scott ALPRIDE AIRBAG Mode D'emploi

5
.6
5
.5
STEP 5
Close the inflator cover
with the zipper.
5.2. CORRECT ATTACHMENT & SETTING
Put the backpack on and adjust shoulder straps to fit your body. Always fasten hipbelt, chest and leg loop and fit them
according to your body. The SCOTT ALPRIDE AIRBAG SYSTEM will only be of use to you if the backpack stays on your
body during an emergency! Most of the weight of the pack should be resting on your hips rather than being carried by
5
.9
your shoulders.
1 CHESTBELT BUCKLE
STEP 1
2 HIPBELT BUCKLE
STEP 1
SCOTT Sports SA shall not be liable for any damages and losses due to incorrect set up, incorrect fitting or incorrect ad-
justments.

6. INSTRUCTIONS

6.1. REGULAR CHECKS

Your SCOTT ALPRIDE avalanche backpack requires no maintenance but the following points have to be observed :
• Deploy the airbag before the new season starts or at least once a year or after the backpack has been exposed to mois-
ture/wet weather. Check its condition, allow it to dry and fold it back together again.
• Pack the airbag away only when it is completely dry.
• Prior to every tour, check all the points described in this user manual and inspect the condition of the system's safety
straps and fastenings.
• Make sure that the cartridges are not pierced (empty) and that the red dot on the inflator systems is not visible on the
inflator cover window.
WBAG_17_MANUAL_alpride_A5_V3.indd 7
5
.8
STEP 6 STEP 7
Pack your backpack for Put the backpack on
your ride. and adjust shoulder
straps, chest belt and
leg loop to fit your
body.
1
Chestbelt buckle
2
5
.7
1
2
STEP 8
Open the zipper sleeve
on the shoulder strap
and take out the trigger
handle when you are on
the slope.
5
.8
1
1
2
Hipbelt buckle
STEP 2
STEP 2
STEP 9
Before your go on your
ride test the specific hand
movement to reach the
trigger handle without
deploying!
2
STEP 3
STEP 3
7- ENGLISH
18.03.16 11:54