AGA marvel MP24RD Instructions D'installation, D'utilisation Et D'entretien page 15

OVERLAY DRAWER PANEL INSTALLATION
Figure 16
3/4 INCH
WOOD PANEL
13/16 COUNTERBORE
1/2 HOLE
NUT
SPRING
LOCK
WASHER
BRASS EXTENSION
Figure 17
Screw clearance
hole through
gasket extrusion
Figure 16a
Overlay panel
flush with top
edge of drawer
Custom overlay
panel should
overhang the sides
of the drawer
(3 mm) each side.
Using clearance holes in
gasket channel mark
hole locations onto panel
1.234" (31.3 mm) Extension
.991" (25.2 mm) Extension
INNER
DOOR
PHILLIPS SCREW
CAM
Step 5: Reinstall the Drawers
1. Fully extend drawer slides and place drawer on slides.
Be sure that drawer sits evenly on both slides and clips
slide into place in rear of drawer.
2. Re-install wire harness at rear corner of top drawer.
3. Re-install two screws through drawer into slides.
15
⁄ "
1
8
Cam stop
washer
Lock
Retainer
nut
Key
Figure 18
Stainless
steel screw
Cam
Spring
washer
Set
screw