Before Using For The First Time - Siemens VSZ3 Série Mode D'emploi

de en
!
Please note
The mains socket must be protected by at least a 16
amp fuse.
If a fuse should blow when you switch on the
appliance, this may be because other electrical
appliances which have a high current draw are
connected to the same power circuit.
To prevent the fuse from blowing, select the lowest
power setting before switching the appliance on, and
increase the power only once it
is running.
Fold out the picture pages.

Before using for the first time

1*
Figure
Push the handle onto the flexible hose until it
engages.
2*
Figure
Push the crevice nozzle and upholstery nozzle into
the accessories holder as illustrated.
Setting up
3
Figure
a)Push the flexible tube adapter into the air intake
opening in the vacuum cleaner lid until it engages.
b)To remove the flexible hose, press the two lugs
together and pull the hose out.
4*
Figure
a) Connect the handle and the telescopic tube together.
b)Push the handle into the telescopic tube until
it engages.
Press on the locking collar and pull out the
telescopic tube to disconnect.
5*
Figure
a)Connect the floor tool and the telescopic tube
together.
b)Push the telescopic tube straight into the connecting
piece of the floor tool until it engages.
Press on the locking collar and pull out the
telescopic tube to disconnect.
6*
Figure
To adjust the length of the telescopic tube, adjust
the adjusting sleeve/sliding switch in the direction of
the arrow and adjust the tube to the required length.
7
Figure
Holding the power cord by the plug, pull out the
required length and plug it into the mains socket.
8
Figure
Press the ON/OFF button in the direction of the
arrow to switch your vacuum cleaner on/off.
9
Figure
Adjust the suction by turning the ON/OFF button in
the direction of the arrow.
Vacuuming
10
Figure
Adjusting the floor tool:
Rugs and carpets
Hard floors
11
Figure
Remove the upholstery nozzle and crevice nozzle
from the accessories holder as illustrated.
12*
Figure
Vacuuming with accessories
Attach the nozzles to the suction pipe or handle as
required:
a)Crevice nozzle for vacuuming crevices and corners,
etc.
b)Upholstery nozzle for vacuuming upholstered
furniture, curtains, etc.
13
Figure
After use, push the crevice nozzle and upholstery
nozzle back into the accessories holder as indicated.
14*
Figure
Pet hair tool
Floor tool for easy and thorough vacuuming of pet
hair. To clean the nozzle, simply vacuum it using the
suction pipe/telescopic tube
Turbo brush
If your appliance is equipped with a turbo brush,
please consult the accompanying instruction manual
for notes on its use and maintenance.
Hard-floor brush
15*
Figure
For vacuuming hard floor coverings (tiles, parquet
flooring, etc.)
Cleaning the hard-floor brush
16*
Figure
a) Vacuum from below to clean the brushes.
b)Cut through threads and hairs wound round the
rollers using scissors.
Vacuum threads and hairs with the crevice nozzle.
17
Figure
You can use the parking aid on the side of the
vacuum cleaner if you wish to stop vacuuming for a
short time.
Once you have switched off the vacuum cleaner,
slide the catch on the floor tool into the groove on
the side of the appliance.
* Dependent on model
=>
=>
7