Disposal Information; Before Using For The First Time - Siemens Z 6.0 Notice D'utilisation

en

Disposal information

Packaging
The packaging is designed to protect the vacuum
cleaner from being damaged during transportation. It
is made of environmentally friendly materials and can
be recycled.
Dispose of packaging that is no longer required at an
appropriate recycling point.
Used vacuum cleaners
Used vacuum cleaners still contain many valuable
materials. Therefore, please take your used vacuum
cleaner to your retailer or recycling centre to be
recycled. For current disposal methods, please
enquire at your retailer or your local council.
Disposal of filters and dust bags
Filters and dust bags are made from environmentally
friendly materials.
As long as they do not contain substances that are
not permitted to be disposed of in the household
rubbish, you can dispose of them with your normal
household rubbish.
!
Please note
The mains socket must be protected by at least a 16
amp fuse.
If a fuse should blow when you switch on the
appliance, this may be because other electrical
appliances which have a high current draw are
connected to the same power circuit.
To prevent the fuse from blowing, select the lowest
power setting before switching the appliance on, and
increase the power only once it
is running.
Fold out the picture pages.

Before using for the first time

1*
Figure
Push the handle onto the flexible hose until it
engages.
Setting up
2
Figure
a)Push the flexible hose adapter into the opening on
the vacuum cleaner until it engages.
b)To remove the flexible hose, press the release
buttons and pull the hose out.
3*
Figure
a) Connect the handle and the telescopic tube together.
b)Push the handle into the telescopic tube until
it engages.
Press on the locking collar and pull out the
telescopic tube to disconnect.
4*
Figure
a) Connect the floor tool and the telescopic tube
together.
b)Push the telescopic tube into the connecting piece of
the floor tool until it engages.
Press on the locking collar and pull out the
telescopic tube to disconnect.
5*
Figure
To adjust the length of the telescopic tube, adjust
the adjusting sleeve/sliding switch in the direction of
the arrow and adjust the tube to the required length.
6
Figure
Take the mains plug, pull the power cord to the
required length and insert the plug into a socket.
7
Figure
Press the ON/OFF button in the direction of the arrow
to switch on your vacuum cleaner.
9