Tally T2045 Manuel D'utilisation page 9

Installing the face down option
↑ ↓
↓
↑
Now place the cover supplied on the printer. This cover replaces the
front cover previously removed and serves as a support for the feed
mechanism.
Holding the cover at a 45 degree angle place it on the printer as shown
in the diagram.
First place the recess on the left side of the cover in the mounting pin on
the printer ( ). Then insert the holder on the right side ( ) into the pin
on the printer and turn the cover down.
Starting on the next page the description is again valid for all models !
5